IBM Turboways 155, Installation And User Manual

Page: 19 / 36

Setting the Hostname, Nameserver, or Gateway
To set the hostname, nameserver, or gateway:
1. At the AIX command prompt, type:
smitty tcpip
and press Enter.
2. From the TCP/IP menu, select Minimum Configuration & Startup.
3. From the list of Available Network Interfaces, select at0.
4. The Minimum Configuration & Startup panel appears.
5. Type the information for the hostname, nameserver, or gateway in the Minimum
Configuration & Startup panel and press Enter.
Note: See your system administrator for the required addresses.
6. When the Command status in the Command Status screen changes from
running
to
OK
, exit SMITTY.
7. To exit SMITTY, press F10.
Configuring PVCs
Note: The TURBOWAYS 155 PCI UTP ATM Adapter can be configured to use
PVCs with or without configuring SVCs.
To configure the TURBOWAYS 155 PCI UTP ATM Adapter to use PVCs:
1. At the AIX command prompt, type:
smitty atmpvc
and press Enter.
2. To add PVCs for internet protocol (IP) on an ATM Network, select Add a PVC
for IP over an ATM Network.
Chapter 3. Configuring and Using ATM155 Software
3-3