IBM TotalStorage L10, Cli Reference Manual

Page: 67 / 96

© Copyright IBM Corp. 2004
55
Chapter 4. Show menu (root/show)
Users can view all of the switch’s current settings (including system, port, zone, and
version settings) at either the Show
menu or, for some settings, the specific submenu.
The Show menu provides information on current switch settings.
Menu commands
Displaying events (root/show/events)
This command displays the event log entries (up to 3000 messages) generated by the
switch. For a list of the severity levels and event messages, see Appendix A. Event
messages on page 67.
To view the event log:
From the Show menu (root/show), type
events
and press E
NTER
.
To continue to list event messages:
Press E
NTER
.
Table 27. Show menu commands
Command Description
Additional
Information
1. events Displays the event log. See page 55.
2. ptype Displays the attributes for a Smart Setting. See page 56.
3. portinfo Displays port configuration information. See page 56.
4. prtctrs Displays the error counters for one or more ports. See page 56.
5. clrctr Clears the counters. See page 56.
6. sysinfo Displays system information. See page 57.
7. zninfo Displays zone information. See page 58.
8. lbinfo Displays load balancing information. See page 58.
9. os Displays the detected ordered sets. See page 59.
10. galpa Displays the port AL_PAs. See page 59.
11. glim Displays the Loop Initialization Master (LIM) port. See page 59.
12. sensors Displays sensor information. See page 59.
13. getcon Displays the connected device ID. See page 60.
14. sync Displays the PLL lock status. See page 60.
15. dump Displays the switch settings. See page 60.
16. sid Displays the SFP serial data. See page 61.
17. zalpas Displays the zone AL_PAs. See page 61.
18. .. Returns to the previous menu. See page 10.
19. ? Displays additional information on a command. See page 10.