IBM TotalStorage L10, Cli Reference Manual

Page: 72 / 96

2006 Model L10 Storage Switch
60
Displaying connected device IDs (root/show/getcon)
This command displays the type of connection for a single port or for all ports. A
connection type of SEOC means that the switch has discovered and successfully
connected to a SEOC-enabled device.
To view the connected device IDs for all ports:
From the Show menu (root/show), type
getcon
and press E
NTER
.
To view the connected device ID for a specific port:
From the Show menu (root/show), type
getcon <port number>
and press E
NTER
.
Displaying PLL lock status (root/show/sync)
This command displays the Phase Loop Lock (PLL) status for a single port or for all
ports. The PLL indicates whether the port is operational or not.
To view the synchronization status for all ports:
From the Show menu (root/show), type
sync
and press E
NTER
.
To view the synchronization status for a specific port:
From the Show menu (root/show), type
sync <port number>
and press E
NTER
.
Displaying switch settings (root/show/dump)
This command displays the current switch settings in XML-tagged format.
Note: This command generates and outputs a significant amount of data. It may take
some time before results are displayed.
To view the switch settings:
1. From the Show menu (root/show), type
dump
and press E
NTER
.
A message appears confirming the request.
2. Type
y
and press E
NTER
.
Table 30. Sensor information
Setting Indicator
Enclosure Temperature Nominal (green)–the switch temperature is within the normal
operating range.
OverTemp (red)–the enclosure temperature has exceeded
the recommended operating range (above 45
o
C).
Fan Nominal (green)–the fan unit is working properly.
Not Present (yellow)–the fan unit has been removed or
cannot be detected.
Fault (red)–the fan unit has stopped operating.