IBM totalstorage fastt100, Installation, User And Maintenance Manual, Page: 78 / 160

3. Remove the two protective caps from the LC connector end of the LC-SC cable
adapter as shown in Figure 40. Save the protective caps for future use.
4. Carefully insert the other end of the LC-LC cable into the LC connector end of
the LC-SC cable adapter as shown in Figure 41. Push in the connector until it
clicks into place.
5. If you are connecting the FAStT100 to a 1-Gbps FC switch or FC Host Bus
adapter, connect the SC connector end of the LC-SC cable adapter to a Gigabit
Interface Converter (GBIC) that is installed in the 1-Gbps FC switch or FC Host
Bus adapter. For more information about connecting to these devices, see the
documentation that comes with the device.
Removing an LC-LC cable from an LC-SC cable adapter
Complete the following steps to remove an LC-LC cable from an LC-SC cable
adapter:
Attention: To avoid damaging the LC-LC cable, make sure you press and hold
the lever to release the latches before you remove the cable from an LC-SC cable
adapter. Ensure that both levers are in the released position when removing the
cable. When removing the cable from the SFP module, make sure you do not grasp
the SFP module plastic tab.
1. On the end of the cable that connects into the LC connector end of the LC-SC
cable adapter, press down and hold the lever to release the latches. Figure 42
on page 49
f10ug013
Figure 40. Removing the LC-SC cable adapter protective caps
f10ug020
Figure 41. Connecting an LC-LC cable into the LC-SC cable adapter
48
IBM TotalStorage FAStT100 Storage Server: Installation, User’s, and Maintenance Guide