IBM totalstorage fastt100, Installation, User And Maintenance Manual, Page: 101 / 160

1. Read the documentation that comes with the hard disk drive.
2. Check for Fault LEDs shown in Figure 55. If any amber LEDs are lit, see
Chapter 6, “Hardware maintenance,” on page 95.
3. Determine the bay into which you want to install the drive.
4. Remove the blank tray:
a. Release the latch on the drive CRU by pinching together the blue line on the
tray latch and the finger hole on the tray handle, as shown by the arrow in
Figure 55.
b. Pull the handle on the tray out so that it is in the open position to release
the drive CRU, and then pull the blank tray out of the bay.
c. Save the blank tray for later use.
5. Install the hard disk drive:
Note: The hard disk drive comes installed in a drive tray. Do not attempt to
detach the drive from the tray.
a. Release the latch on the drive CRU by pinching together the blue line on the
tray latch and the finger hole on the tray handle.
b. Pull the handle on the tray out so that it is in the open position, as shown in
Figure 56.
Tray handle
Tray latch
f10ug049
Activity LED
Fault LED
General system
error LED
Power-on LED
Latch Tray handle
f10ug053
Figure 55. Hot-swap hard disk drive LEDs
Figure 56. Drive CRU handle
Chapter 5. Installing and replacing components
71