IBM ThinkPad T30 Series, Service And Troubleshooting Manual

Page: 32 / 104

For Windows NT:
If you enable the CD-ROM AutoRun feature, the timer cannot trigger the
computer to enter standby mode. To enable the timer, disable the AutoRun
feature by editing the configuration information in the registry as follows:
HKEY_LOCAL_MACHINE\SYSTEM\
CurrentControlSet\Services\Cdrom\
Autorun: 0x1 > Autorun:
0
Problem: The Fn+F12 key combination does not cause the computer to enter
hibernation mode.
Solution: The computer cannot enter hibernation mode:
v
If you are using one of the IBM communication PC Cards. To enter
hibernation mode, stop the communication program, and then remove the
PC Card or disable the PC Card slot, using the Control Panel.
v
If the hibernation utility is not installed in Windows 98 or Windows NT. To
install the hibernation utility, refer to “Installing device drivers” in the
Access ThinkPad, your on-board help system.
v
If the hibernation mode is not enabled. To enable it, do as follows:
For Windows 98:
1. Start the ThinkPad Configuration Program.
2. Click Power Management .
3. Click the Hibernation tab.
4.
Click the Enable hibernation button.
5. Click the Create Now button.
For Windows NT:
Note:
You must format your hard disk with the FAT format system to use
hibernation mode in Windows NT. If you format your hard disk with
NTFS, the default format in Windows NT, you cannot use hibernation
mode.
1. Start the ThinkPad Configuration Program.
2. Click Power Management .
3. Click Suspend/Resume Options .
4.
Click Enable Hibernation .
5.
Click
OK
.
For Windows 2000 or Windows XP:
1. Start the ThinkPad Configuration Program.
2.
Click Power Management .
Solving computer problems
20
ThinkPad
®
T30 Series Service and Troubleshooting Guide