Digital
code
Word code
Meaning
86
Connect
16800EC*
The modem was connected at 16800
bps.
87
Connect
115200EC*
The modem was connected at 115200
bps.
88
Delayed
89
Blacklisted
90
Blacklist full
* EC appears only when the extended result codes configuration
option (AT\V1) is enabled. EC is replaced by one of the
following symbols, depending on the error control method used:
V.42bis: V.42 error control V.42bis data compression
V.42: V.42 error control only
MNP 5: MNP class 4 error control and MNP class 5 data
compression
MNP 4: MNP class 4 error control only
NoEC: No error control protocol
S registers
S registers are information storage areas inside the modem. The AT
command set users the S registers to configure modem options.
Some S registers have default settings. For normal modem
operations, the defaults settings are usually adequate. However,
special circumstances might require you to change some defaults.
To change or read the value of an S register, begin the command
with the letters AT.
To read the value of an S register, use the
ATSr?
command
(
r=register number 0–110).
For example, to read the value of S register 0, type
ATS ?
and press
Enter.
Appendix B. Using modem commands
127
Summary of Contents for ThinkPad 570
