Chapter 6. Remote management and system diagnostics
You can use the command-line interface of the EXP2500 environmental service
module (ESM) to perform system diagnostics and other subsystem management
tasks. Before you can issue any commands, you must connect to the EXP2500
ESM Ethernet port, establish a session with the EXP2500 ESM, and then launch its
command-line interface.
Launching the EXP2500 ESM command-line interface
Complete the following steps to launch the EXP2500 ESM command-line interface:
1. Use Telnet, or a terminal application that supports Telnet, to connect to the
EXP2500 ESM Ethernet port that has a default address of 192.168.128.101 and
a subnet mask of 255.255.0.0.
2. Enter USERID as the login name and press ENTER. Leave the password field
blank. The command-line interface launches.
See EXP2500 ESM command-line reference for the list of commands.
EXP2500 ESM command-line reference
Table 7. List of Commands the EXP2500 Environmental Service Module (ESM) Supports
Command Usage
Description
dhcp on|off
timeout_in_ seconds
Enables/Disables DHCP. Specify timeout. 0 (zero) or unspecified means no
timeout
cfgip
IP_address Subnet_mask
gateway
Sets IP configuration. Example: cfgip 192.168.0.3 255.255.255.0 192.168.0.2
collsvcsnap
Displays all config and status information, such as error logs and state
capture buffers
dmesg
Displays the history buffer of system print strings
drivetemps
Gets current disk-drive temperatures
drvpres
startphy endphy
Displays present status of the drive
dumperrorlog
Displays error log contents as hex records
enclamptest on|off
Turns on or off all LEDs for testing purposes
esmcompatcheck
Resets the ESM
esmstatus
Shows the lockdown status of the ESM
istat
Provides chassis-specific expander information
netif
Displays MAC and TCP/IP addresses for all network interfaces
password
new_password
Changes the user password
phyerrregs
phyStart [phyEnd]
Displays PHY Error Registers on PHY phynum (in hex)
phystat
Prints PHY Status Table
ping
host_name_length
Issues a single ICMP 'Echo Request' packet to a specified host. Length is
the 'send buffer' size. Default is 56 bytes
showenc
Displays Detailed Enclosure Inventory Data
showfwlevels
Displays firmware levels for all devices connected to the system
showinventory
Displays information about all the components
uptime
Informs how long the system has been running
© Copyright IBM Corp. 2010, 2011
43
Summary of Contents for System Storage EXP2512 Express Storage Enclosure
