IBM Storwize V3700, Quick Installation Manual

Page: 49 / 82

Procedure
To install the memory module option, complete the following steps.
1.
Open the retaining clip on each end of the memory module connector as
shown in Figure 20.
Attention: To avoid breaking the retaining clips or damaging the memory
module connectors, open and close the clips gently.
2.
Touch the static-protective package that contains the memory module to any
unpainted metal surface on the outside of the canister.
3. Remove the memory module from the package.
4.
Turn the memory module so that the keys align correctly with the connector.
5. Insert the memory module into the connector by aligning the edges of the
module with the slots at the ends of the connector (see Figure 20).
6. Firmly press the memory module straight down into the connector by applying
pressure on both ends of the module simultaneously. The retaining clips snap
into the locked position when the module is firmly seated in the connector.
Note: If you can see a gap between the module and the retaining clips, the
module has not been correctly inserted. Open the retaining clips, remove the
module, and then reinsert it.
v3500052
Figure 20. Installing memory module option
Chapter 2. Installing the hardware
29