b.
Check the alignment of the slides by sliding the switch in and out of the
rack. Any difficulty moving the switch indicates lateral stress or
misalignment. If this situation occurs, adjust the slide positions until the
movement is smooth.
8.
Optional step: If the right and left rack mount brackets are installed on the
front corners of the switch, attach both brackets to the cabinet rack by using M5
x 12 screws
7
. See step 4 on page 16 and Figure 7 on page 14. The screws
should pass through the front of each bracket and the slide rail.
Note:
Some rack mount kits might use 10-32 nut clips in place of the M5 nut
clips for the locking ears.
9.
Continue with initial setup of the switch by following the procedures in
“Configuring the switch” on page 19.
Attention:
Do not connect the switch to the network until you perform one of
the following steps:
v
Set the internet protocol (IP) address.
v
Verify that the default IP address does not conflict with the existing IP
addresses in the same network.
SJ000049
Figure 11. Inserting slides into the rack rails
18
SAN32B-E4 Installation, Service, and User Guide
Summary of Contents for SAN32B-E4
