IBM RS/6000 7043 43P Series, Service Manual

Page: 71 / 273

Step 1540A-8
1. Turn the power off.
2. Reconnect the system console.
Notes:
a. If an ASCII terminal has been defined as the system console, attach the
ASCII terminal cable to the S1 connector on the rear of the system unit. Also
connect the internal serial and Ethernet cables to the system board.
b. If a display attached to a display adapter has been defined as the system
console, install the display adapter and connect the display to it. Plug the
keyboard into the keyboard connector on the rear of the system unit.
3. Turn the power on.
4. If the ASCII terminal or graphics display (including display adapter) are
connected differently than before, the Console Selection screen will appear and
require that a new console be selected.
5. When the keyboard indicator is displayed, press the F1 key on the directly
attached keyboard or the number 1 key on an ASCII terminal. This triggers the
SMS.
6. Enter the appropriate password when prompted to do so.
7. Wait until the SMS screen is displayed or the system appears to stop.
Chapter 2. Maintenance Analysis Procedures (MAPs)
2-29