IBM Power System 8284-22A, Installing Instructions

Page: 24 / 66

7. Place the cable-management arm (D) on the support arm (A) . Slide the first cable-management arm
tab into the slot on the mounting bracket (C) . Push the tab until the spring-loaded latch snaps into
place. Slide the other cable-management arm tab into the extension bracket (E) on the outside of the
right slide rail (2) . Push the tab until the spring-loaded latch snaps into place. For details, see
Figure 15.
Cabling the server and setting up a console
Your console, monitor, or interface choices are guided by whether you create logical partitions, which
operating system you install in your primary partition, and whether you install a Virtual I/O Server
(VIOS) in one of your logical partitions.
Determining which console to use:
Your console, monitor, or interface choices are guided by whether you create logical partitions, which
operating system you install in your primary partition, and whether you install a Virtual I/O Server
(VIOS) in one of your logical partitions.
Choose one of the consoles, interfaces, or terminals in the following table.
Figure 14. Installing the mounting bracket into the slide rail
Figure 15. Connecting the cable-management arm
10
Power Systems: Installing the IBM Power System S822 (8284-22A)