IBM Power System 8284-21A, Installing

Page: 39 / 62

b.
Connect the system power cords from the server and I/O drawers to the PDU with an IEC 320
type receptacle.
c. Attach the PDU input power cord and plug it into the power source.
Cabling the server and setting up a console
Your console, monitor, or interface choices are guided by whether you create logical partitions, which
operating system you install in your primary partition, and whether you install a Virtual I/O Server
(VIOS) in one of your logical partitions.
Determining which console to use:
There are different console types available to manage this server. Learn more about the consoles that are
available.
Go to the instructions for the applicable console, interface, or terminal in the following table.
Table 6. Available console types
Console type Operating system Logical partitions Cable required
Cabling setup
instructions
ASCII terminal AIX No Serial cable equipped
with a null modem “Cabling the server
with an ASCII
terminal” on page 24
Hardware
Management Console
(HMC) AIX Yes Ethernet (or
cross-over cable) “Cabling the server
to the HMC” on page
25
Figure 19. Plugging the power cords into the power supply and attaching cables to the power supply handles
Installing the IBM Power System S812 (8284-21A)
23