Installing a U-Bolt
You can add a U-bolt to the rear of your computer. Adding a U-bolt enables you to
add a security cable and lock that helps prevent hardware theft. After you add the
security cable, make sure that it does not interfere with other cables that are
connected to the computer.
Before you begin
Obtain the following:
– A 19-mm (3/4 in.) U-bolt and threaded nuts that fit the U-bolt
– A security cable
– A lock, such as a combination lock or padlock
– An adjustable wrench
Read “Electrical Safety” on page 4 and “Handling Static-Sensitive Devices”
on page 5.
Turn off the computer and all connected devices.
Disconnect all external cables and power cords, and remove the computer
cover (see “Disconnecting Cables and Removing the Cover” on page 6).
Note:
The external connectors on the rear of your computer might differ from the
ones shown in this section.
1
Locate the two holes on the lower right edge of the rear of the computer.
2
Insert the U-bolt through the rear panel; then, attach and tighten the nuts with
an adjustable wrench.
Chapter 6. Working with Security Options
71
All manuals and user guides at all-guides.com
Summary of Contents for PC 300PL
Page 2: ...All manuals and user guides at all guides com...
Page 14: ...xii Installing Options in Your Personal Computer All manuals and user guides at all guides com...
Page 99: ...Chapter 7 Completing the Installation 85 All manuals and user guides at all guides com...
Page 111: ...All manuals and user guides at all guides com a l l g u i d e s c o m...
