IBM NetVista 8302, Hardware Maintenance Manual

Page: 79 / 314

6. Pull out and lift up the processor socket lever arm upward to its maximum
vertical position to release the processor.
7.
Lift the processor out of the system board.
Notes:
a. When installing the new processor, make sure to reinstall the fansink to
insure proper cooling.
b. When installing the same fansink/processor, make sure to align the fansink
in the same direction it was when it was removed, as this will ensure there
are no gaps in the thermal grease.
Hard disk drive removal
Types 8303, 8304, and 8312
This section provides information and instructions for installing and removing
internal drives.
Internal drives are devices that your computer uses to read and store data. You can
add or replace drives to your computer to increase storage capacity and to enable
your computer to read other types of media such as CD-ROM.
Internal drives are installed in bays . Within this book, the bays are referred to as
bay 1, bay 2, and so on.
When you install an internal drive, it is important to note what type and size of
drive that you can install in each bay. Also, it is important to correctly connect the
internal drive cables to the installed drive.
Drive specifications
Notes:
1. Drives that are greater than 41.3 mm (1.6 in.) high cannot be installed.
2. Install removable media (tape or CD) drives in the accessible bay: bay 2.
Installing a drive
To install a hard disk drive, follow these steps.
1.
Remove the cover (see “Removing the cover” on page 40).
2. Make sure the drive is set correctly as the master device. Refer to the
documentation that comes with your drive for master/slave jumper
information.
Chapter 6. FRU Removals
73