IBM NetVista 8302, Hardware Maintenance Manual

Page: 10 / 314

DID YOU RECEIVE THE CORRECT RESPONSE?
If NO, continue to
002
.
If YES, proceed to
003
.
002
If the Power Management feature is enabled, do the following:
1. Start the Configuration/Setup Utility program (see “Setup Utility program” on
page 24)
2.
Select
Power Management
from the Configuration/Setup Utility program
menu.
3. Select APM .
4.
Be sure APM BIOS Mode is set to Disabled . If it is not, press Left Arrow (
}
) or
Right Arrow (Æ) to change the setting.
5. Select Automatic Hardware Power Management .
6. Set Automatic Hardware Power Management to Disabled .
7. If the problem persists, continue to
003
.
003
Run the Diagnostic programs. If necessary, refer to “Diagnostics” on page 26.
v
If you receive an error, replace the part that the diagnostic program calls out or
go to
″
Symptom-to-FRU Index
″
on page 87.
v
If the test stops and you cannot continue, replace the last device tested.
4
Hardware Maintenance Manual