IBM NetVista 8302, Hardware Maintenance Manual

Page: 64 / 314

position.
6. Make sure the drive that you are installing is set correctly as either a master or
a slave device.
v
If it is a hard disk drive, set it as a slave device.
v If it is the first CD drive or DVD drive, set it as a master device.
v
If it is an additional CD drive or DVD drive, set it as a slave device.
Refer to the documentation that comes with your drive for master/slave
jumper information.
7. Install the drive into the bay. Align the screw holes and insert the two screws.
8. Pivot the drive-bay cage back into place.
9. Each integrated drive electronics (IDE) drive requires two cables; a four-wire
power cable that connects to the power supply and a signal cable that connects
to the system board.
The steps to connect an IDE drive are different depending on the type of drive you
are connecting. Use one of the following procedure for your drive connection.
58
Hardware Maintenance Manual