IBM NetVista 6644, User Manual, Page: 28 / 110

14
User Guide
The following is a description of the controls and status indicators for your
computer.
Power button: Press this button to turn your computer on or off. Do not turn off
your computer if the in-use indicator for the hard disk drive or diskette drive
(USB optional drive) is on.
Note: The power button normally operates with a single touch. However, in
some circumstances the computer might not immediately turn off. If this
happens, hold the power button down for approximately five seconds, and
the computer will then turn off.
Power/standby indicator: This status indicator is on when power to your
computer is turned on, and blinking when in standby mode.
Hard disk drive in-use indicator: When this light is on, it indicates that the hard
disk drive heads are being positioned or that your computer is reading from or
writing to the hard disk. Do not turn off your computer when this indicator is on
or blinking.
Emergency eject hole: Insert a pin to open the tray for removing a disc when the
computer is turned off.
CD-ROM eject button: Press this button on the CD-ROM drive to open the tray
for inserting or removing a disc.
CD-ROM in-use indicator: When this light is on, it indicates that the CD-ROM
drive is in use.
Volume control:
During audio CD playback, adjusts the volume of the
headphone connected to the headphone jack on the CD-ROM drive.
Starting your computer
What you see and hear when you turn on your computer depends on the settings
in the Start Options menu of the Configuration/Setup Utility program. For more
information, see “Chapter 4. Using the Configuration/Setup Utility program,” on
page 27.
If any errors are detected during POST, error messages are displayed. If a power-
on password is set, a password prompt is displayed on the screen. If you have set
both power-on and administrator passwords, you can type either password at the
password prompt. When you type your password at the prompt and press Enter,
the first screen of your operating system or application program is displayed.