IBM NetVista
A
Pin 1
CD-ROM
B
C
CDIN1
CDIN2
D
CD-ROM audio
connector
Colored
stripe
Note:
The ribbon cable connectors are keyed so that they can only be
installed correctly on the device connector. If the connector is not
keyed, make sure that you match the pin-1 side of the cable connector
with the pin-1 side of the device connector. Each connector has the
pin-1 side clearly marked. The pin-1 side of each ribbon cable is
always marked with a colored stripe on the cable.
3. Plug an IDE cable connector into the CD-ROM/DVD drive IDE
connector (B). It doesn't matter which connector on the cable
you use.
4. Plug a power cable from the case power supply into the power
connector on the CD-ROM/DVD drive (C).
5. Use the audio cable provided with the CD-ROM/DVD drive to
connect to the system board CD-in connector CDIN1 or CDIN2
(D).
When you first start up your system, the BIOS should automatically detect your
CD-ROM/DVD drive. If it doesn’t, enter the Setup Utility and configure the CD-
ROM/DVD drive that you have installed.
25/
53