![background image](http://html1.mh-extra.com/html/ibm/netfinity-exp300/netfinity-exp300_installation-and-user-manual_3995972039.webp)
Chapter 3. Installing and replacing devices
27
2. Check for fault LEDs. If any amber LEDs are lit, refer to “Troubleshooting” on
3. Determine the bay into which you want to install the drive.
4. Remove the filler panel.
a. Insert a finger into the square hole at the top of the filler panel to grip and pull
the panel out of the drive bay.
b. Save the filler panel for later use.
5. Install the drive CRU:
Note:
The hard disk drive comes with a tray already attached. Do not attempt
to detach the drive
4
from the tray
3
.
a. Release the blue latch
1
on the drive CRU by pressing on the inside of the
bottom of the tray handle
2
.
b. Pull the handle
2
on the tray out into the open position.
c. Slide the drive CRU into the empty bay until the tray handle
2
touches the
expansion-unit bezel.
d. Push the tray handle
2
down into the closed (latched) position.
6. Check the drive LEDs.
a. When a drive is ready for use, the green activity LED and the amber fault
LED are off.
Drive CRU
Filler panel
Tray handle
Latch
Fault LED
Activity LED
Summary of Contents for Netfinity EXP300
