IBM Netfinity 7100, Installation Manual

Page: 25 / 60

Chapter 2. Installing options
15
The illustrations in this document might differ slightly from your hardware.
Attention: When you handle Electrostatic Discharge-Sensitive devices (ESD), take
precautions to avoid damage from static electricity. For details on handling these
devices, refer to the following Web site and use a search term of ESD:
http://www.ibm.com/
To install an additional power supply:
1. Review the information in “Safety” on page v.
2. Remove the filler panel.
3. Place the handle on the power supply in the open position.
4. Slide the power supply into the chassis and press the handle to the closed
position.
5. Plug the power cord into the power supply; then, into a properly grounded
electrical outlet.
6. Verify that the DC Power light and the AC Power light on the power supply are
lit, indicating that the power supply is operating properly.
Statement 6
CAUTION:
If you install a strain-relief bracket option over the end of the power cord that is
connected to the device, you must connect the other end of the power cord to an
easily accessible power source
AC power light DC power light
Handle
Filler panel