IBM Netfinity 6000R, Installation Manual

Page: 34 / 66

22
IBM® Netfinity® 6000R Installation Guide
• If the server is turned on and a power failure occurs, the server will start
automatically when power is restored.
• The Netfinity Advanced System Management Processor also can turn on the
server.
You can turn off the server in several ways:
• You can press the power-control button on the front of the server to turn off the
server.
Note:
After turning off the server, wait at least five seconds before pressing the
power-control button to turn on the server again.
• You can disconnect the server power cords from the electrical outlets to shut off
all power to the server.
Note: Wait about 15 seconds after disconnecting the power cords for your
system to stop running. Watch for the system-power light on the
information panel to stop blinking.
Statement 5
CAUTION:
The power control button on the device and the power supply do not turn off
the electrical current supplied to the device. The device also might have more
than one power cord. To remove all electrical current from the device, ensure
that all power cords are disconnected from the power source.
1
2
3