IBM Netfinity 4500R, Hardware Maintenance Manual

Page: 30 / 192

22
Hardware Maintenance Manual: Netfinity 4500R Type 8656
Network driver interface specification 2.01 (OS/2) driver
messages
This section provides explanations of the error messages for the NDIS 2.01 (OS/2)
drivers, and suggested actions to resolve each problem.
PCNTNW-NW-180 The DMA parameter is not necessary for PCI device.
Explanation: The Ethernet controller does not require a DMA setting.
Action: None necessary, message is for information only.
Table 3. NDIS 2.01 (OS/2) driver messages for the Ethernet controller.
PCNTND-1 Unable to open the Protocol Manager .
Explanation: The NDIS stack is not configured correctly. Action: Check
and correct your configuration.
PCNTND-6 Out of memory while allocating buffers.
Explanation: The driver could not allocate the requested buffers. Action:
Check your system configuration. Edit the PROTOCOL.INI file to reduce the number of
Txbuffers and Rxbuffers specified for the driver.
PCNTND-7 A Protocol Manager device error occurred.
Explanation: The NDIS stack is not configured correctly. Action: Check
and correct your configuration.
PCNTND-8 Bad status for the Protocol Manager.
Explanation: The NDIS stack is not configured correctly in the PROTOCOL.INI file.
Action: Check and correct your configuration.
PCNTND-9 Cannot find the PROTOCOL.INI entry.
Explanation: The NDIS stack is not configured correctly in the PROTOCOL.INI file.
Action: Check and correct your configuration.
PCNTND-10 The Protocol Manager Input Output Control (IOCTL) failed.
Explanation: The NDIS stack is not configured correctly in the PROTOCOL.INI file.
Action: Check and correct your configuration.
PCNTND-11 Protocol Manager registration failed.
Explanation: The NDIS stack is not configured correctly. Action: Check
and correct your configuration.
PCNTND-15 Device not found.
Explanation: The driver cannot find an Ethernet controller in the server. Action:
Verify that the Ethernet controller is enabled. If the Ethernet controller is enabled, go to
“Starting the diagnostic programs” on page 14 to run the diagnostic programs.
PCNTND-16 PCI scan specified, device not found.
Explanation: The driver cannot locate the Ethernet controller on the PCI bus. Action:
Verify that the Ethernet controller is enabled. If the Ethernet controller is enabled, go to
“Starting the diagnostic programs” on page 14 to run the diagnostic programs.
Table 2. Novell NetWare or IntraNetWare ODI driver messages for the Ethernet controller.