IBM N7800, Hardware And Service Manual

Page: 76 / 182

2. Download the
image.tgz
file from the IBM N series support website to the
web-accessible directory. Your directory listing should contain the following
file and directory:
image.tgz netboot/
3. If you are not already grounded, properly ground yourself.
4. Remove the bezel, if necessary, and locate the CompactFlash card slot in the
LCD module.
5. Align the CompactFlash card with the CompactFlash card socket or connector,
and then firmly push the CompactFlash card into the socket or connector. The
CompactFlash card socket is keyed. If you feel resistance while pushing the
card into the socket, check the orientation of the card.
6.
Check the CompactFlash card to make sure that it is seated squarely and
completely in the socket or connector. If necessary, remove the CompactFlash
card and reseat it into the socket.
7. Replace the bezel.
8. Reinstall the cable management tray and recable the system, as needed. When
recabling, remember to reinstall the media converters (SFPs) if you are using
fiber cables.
9. Push the motherboard tray all the way into the system, firmly push the cam
handle to finish seating it, push the cam handle to the closed position, and
then tighten the thumbscrews.
10. Reconnect the power cables to the power supplies and to the power sources,
and then turn on the power.
11.
Depending on your network configuration, enter one of the following
commands at the LOADER:
If you... Then...
Have DHCP enabled Enter the following command:
ifconfig e0a -auto
50
IBM System Storage: N7000 Series Hardware and Service Guide