IBM N7800, Hardware And Service Manual

Page: 133 / 182

If your system uses... Use this method to disconnect the cables...
Copper interconnect cables Remove each cable by carefully pressing the latches on the cable and using the
handles to slowly pull the connector from the NVRAM adapter port, as shown in the
following illustration:
LO2 PH2
NVRAM5
LO1 PH1
Pull handle
Press latch
Opening the system
To access components inside the motherboard tray, you must open the system.
Procedure
1.
If you are not already grounded, properly ground yourself.
2. Unplug the system cables and SFPs from the motherboard tray, as needed, and
keep track of where the cables were connected. Leave the cables in the cable
clips of the cable management tray so that when you reinstall the cable
management tray, the cables are already aligned.
Chapter 5. Replacing N7000 series system devices
107