IBM N Series, Hardware Manual

Page: 338 / 368

318
IBM System Storage N series Hardware Guide
.
.
Please enter the new hostname []:
g. Complete the initial setup. See Example A-6 for the initial setup.
h. Install the full operating system. FilerView can be used after the full operating system is
installed.
The full installation procedure is similar to the Data ONTAP update procedure. For
more information, see “Updating Data ONTAP” on page 319.
3. The system begins to boot. Complete the initial setup by answering all the installation
questions as in the initial worksheet. For more information, see the IBM System Storage
Data ONTAP Software Setup Guide, GA32-0530.
See Example A-6 for N3300 setup.
Example A-6 Setup
Please enter the new hostname []: n3000a
Do you want to configure virtual network interfaces? [n]:
Please enter the IP address for Network Interface e0a []: 9.11.218.246
Please enter the netmask for Network Interface e0a [255.0.0.0]: 255.255.255.0
Should interface e0a take over a partner IP address during failover? [n]:
Please enter media type for e0a {100tx-fd, tp-fd, 100tx, tp, auto (10/100/1000)} [auto]:
Please enter flow control for e0a {none, receive, send, full} [full]:
Do you want e0a to support jumbo frames? [n]:
Please enter the IP address for Network Interface e0b []:
Should interface e0b take over a partner IP address during failover? [n]:
Would you like to continue setup through the web interface? [n]:
Please enter the name or IP address of the default gateway: 9.11.218.1
The administration host is given root access to the filer's
/etc files for system administration. To allow /etc root access
to all NFS clients enter RETURN below.
Please enter the name or IP address of the administration host:
Where is the filer located? []: Tucson
Do you want to run DNS resolver? [n]:
Do you want to run NIS client? [n]:
This system will send event messages and weekly reports to IBM Technical Support. To
disable this feature, enter "options autosupport.support.enable off" within 24 hours.
Enabling Autosupport can significantly speed problem determination and resolution should
a problem occur on your system.
Press the return key to continue.
The Baseboard Management Controller (BMC) provides remote management capabilities
including console redirection, logging and power control.
It also extends autosupport by sending down filer event alerts.
Would you like to configure the BMC [y]: n
Name of primary contact (Required) []: administrator
Phone number of primary contact (Required) []: 1-800-426-4968
Alternative phone number of primary contact []: 1-888-7467-426
Primary Contact e-mail address or IBM WebID? []: admin@itso.tucson.ibm.com
Name of secondary contact []:
Phone number of secondary contact []:
Alternative phone number of secondary contact []:
Secondary Contact e-mail address or IBM WebID? []:
Business name (Required) []: itso
Business address (Required) []: Rita Road
City where business resides (Required) []: tucson
State where business resides []: arizona