7.
Commit the configuration to activate it on the device.
[edit]
root@#
commit
8.
Log in as the administrative user you configured in step 6.
9.
Configure the name of the device. If the name includes spaces, enclose the name
in quotation marks (“ ”).
configure
[edit]
admin@#
set system host-name
host-name
10.
Configure the IP address and prefix length for the device’s Ethernet interface.
[edit]
admin@#
set interfaces fxp0 unit 0 family inet address
address/prefix-length
11.
Configure the traffic interface.
[edit]
admin@#
set interfaces ge-0/0/0 unit 0 family inet address
address/prefix-length
admin@#
set interfaces ge-0/0/1 unit 0 family inet address
address/prefix-length
12.
Configure the default route.
[edit]
admin@#
set routing-options static route 0.0.0.0/0 next-hop
gateway
13.
Configure basic security zones and bind them to traffic interfaces.
[edit]
admin@#
set security zones security-zone trust interfaces ge-0/0/0
admin@#
set security zones security-zone untrust interfaces ge-0/0/1
14.
Configure basic security policies.
[edit]
admin@#
set security policies from-zone trust to-zone untrust policy
policy-name
match source-address any destination-address any application any
root@#
set security policies from-zone trust to-zone untrust policy
policy-name
then permit
15.
Check the configuration for validity.
[edit]
admin@#
commit check
configuration check succeeds
16.
Commit the configuration to activate it on the device.
[edit]
admin@#
commit
commit complete
17.
Optionally, display the configuration to verify that it is correct.
20
■
Step 6: Perform the Initial Software Configuration
IBM Ethernet Appliance J36S Getting Started Guide
