IBM ILC300, User Manual

Page: 20 / 62

described directly above (the yellow connectors on the video cable are not used).
computer 1
computer 2
video
monitor
network
serial control
audio in
audio in
audio in
audio out
R
R
L
L
Y
Pr
Pb
s-video
computer in
If the video device uses component cable connectors (sold separately), plug the
cable’s green connectors into the green component-out connector on the video
device and into the green component connector (labeled
Y ) on the projector. Plug
the component cable’s blue connectors into the blue component- out connector on
the video device and into the blue component connector (labeled
Pb ) on the
projector. Plug the component cable’s red connectors into the red component-out
connector on the video device and into the red component connector (labeled
Pr )
on the projector. Use the video cable’s audio connectors as described directly above
(the yellow connectors on the video cable are not used).
computer 1 computer 2
video
monitor
network
serial control
audio in
audio in
audio in
audio out
R
R
L
L
Y
Pr
Pb
s-video
computer in
Displaying a video image
To display a video image:
1. Remove the lens cap.
2. Press the Power button on the top of the projector.
The LED flashes green and the fans start to run. When the lamp comes on, the
startup screen is displayed and the LED is steady green. It can take a minute
for the image to achieve full brightness. If you do not see a startup screen see
Appendix B, “Troubleshooting your setup”, on page 27.
3.
Plug in and turn on the video device.
The video device’s image should appear on the projection screen. If it does not,
press the
Video button.
4. Position the projector the desired distance from the screen at a 90 degree angle
to the screen.
5. Adjust the zoom or focus rings by rotating them until the desired image size
and sharpness are produced.
6. If the image is not square, adjust the keystone using the buttons on the keypad.
Press the upper Keystone button to reduce the upper part of the image, and
press the lower Keystone button to reduce the lower part.
7.
Adjust the volume on the keypad or the remote.
10
IBM iLC300 Conference Projector: IBM iLC300 Conference Projector User’s Guide