IBM IC25N005ATDA04, Specifications

Page: 179 / 220

13.30 Set Max ADDRESS (F9h)
see below Status 1 1 1 1 1 0 0 1 Command
- - - - H H H H Device/Head 1 L 1 D H H H H Device/Head
V V V V V V V V Cylinder High V V V V V V V V Cylinder High
V V V V V V V V Cylinder Low V V V V V V V V Cylinder Low
V V V V V V V V Sector Number V V V V V V V V Sector Number
- - - - - - - - Sector Count - - - - - - - B Sector Count
see below Error V V V V V V V V Feature
- - - - - - - - Data - - - - - - - - Data
7 6 5 4 3 2 1 0 Register 7 6 5 4 3 2 1 0 Register
Command Block Input Registers Command Block Output Registers
V - 0 - - 0 V 0 0 0 V 0 0 0 0 0
ERR IDX COR DRQ DSC DF RDY BSY AMN T0N ABT 0 IDN 0 UNC CRC
0 1 2 3 4 5 6 7 0 1 2 3 4 5 6 7
Status Register Error Register
Figure 113. Set Max ADDRESS (F9h)
The Set Max ADDRESS command overwrites the max LBA/CYL of HDD in a range of actual device
capacities. Once the device receives this command, all accesses beyond that LBA/CYL are rejected by
setting the ABORT bit in the status register. Identify the device command and Identify the device DMA
command returns the LBA/CYL which is set via this command as a default value.
This command implement SET MAX security extension commands as subcommands. But regardless of
Feature register value, the case this command is immediately preceded by a Read Native Max ADDRESS
command, it is interpreted as a Set Max ADDRESS command.
The Read Native Max ADDRESS command should be issued and completed immediately prior to issuing
the Set Max ADDRESS command. If it is not, this command is interpreted as a Set Max security extension
command which is designated by feature register.
If Set Max security mode is in the Locked or Frozen, the Set Max ADDRESS command is aborted.
For more information, see Section 11.9.2, "Set Max security extension commands" on page 95.
In CHS mode, Cylinder High, Cylinder Low specify the maximum cylinder number. The Head number of
DEVICE/HEAD and Sector Number are ignored. The default value (see default CHS in Identify device
information) is used for that.
In LBA mode, the Head number of DEVICE/HEAD , the Cylinder High, the Cylinder Low, and the Sector
Number specify the max LBA. This command will set this LBA as the max LBA of the device.
Travelstar 48GH, 30GN & 15GN hard disk drive specifications
165