IBM Eserver xSeries 360 Type 8686, Installation Manual

Page: 28 / 74

18
IBM xSeries 360 Type 8686:Installation Guide
6. Remove the heat sink from its package and secure it to the top of the micropro-
cessor (two thumbscrews). Press firmly on the thumbscrews and tighten them,
alternating between screws until finger tight. Do not overtighten the screws.
7. Install the heat-sink stabilizer.
8. If you have other options to install or remove, do so now; otherwise, go to “Com-
pleting the installation” on page 19.
Installing a hot-swap power supply
The server comes with a minimum of one power supply and supports up to three
power supplies. If you install or remove a power supply, observe the following precau-
tions.
Statement 8:
CAUTION:
Never remove the cover on a power supply or any part that has the following
label attached.
Hazardous voltage, current, and energy levels are present inside any compo-
nent that has this label attached. There are no serviceable parts inside these
components. If you suspect a problem with one of these parts, contact a ser-
vice technician.
Complete the following steps to install a hot-swap power supply:
1. Review the safety precautions beginning on page v.
2. Remove the bezel. See “Removing the server top cover and bezel” on page 7.
3. Remove the appropriate power-supply filler panel by inserting a finger into the
hole and pulling the panel forward. The panel pivots at the top.