IBM eServer 232 xSeries, User Reference Manual

Page: 92 / 174

78
IBM xSeries 232: User’s Reference
Input/output ports
I/O por ts Your server has the following input/output (I/O) ports:
• One video port
• One system management port
• Two Integrated System Management ports
• Two Universal Serial Bus (USB) ports
• One Ethernet port
• One keyboard port
• One auxiliary pointing device (mouse) port
• Two serial ports
• Dual Channel Utra160 (internal connectors only)
Video port
Your server comes with an integrated super video graphics array (SVGA) video
controller. This controller is not removable, but you can disable it by installing a PCI
video adapter.
Note: If you install a PCI video adapter, the server BIOS code will automatically
disable the integrated video controller.
The following table shows the pin-number assignments for the 15-pin analog video
connector on the rear of your server.
Integrated System management ports
Your server has one communication port dedicated to system management. This port
uses a standard D-shell serial-port connector, serial C. Future releases of the
Integrated System Management (ISM) firmware code will enable the Integrated
System Management processor to communicate using a modem and this dedicated
serial port.
Pin Signal Pin Signal Pin Signal
1 Red 6 Ground 11 Not connected
2 Green or monochrome 7 Ground 12 DDC SDA
3 Blue 8 Ground 13 Horizontal synchronization
(Hsync)
4 Not connected 9 +5 V dc
DDC 14 Vertical synchronization (Vsync)
5 Ground 10 Ground 15 DDC SCL
Table 4. Video-port connector pin-number assignments.
1 5
11 15