66
IBM xSeries 232: User’s Reference
7.
Set the fan sink into place.
Make sure the fan sink guide fits between the processor and the processor
socket.
8.
Press down and latch the spring retention clip on the back of the fan sink (the side
facing the back of the server).
9.
Press down and latch the spring retention clip on the front of the fan sink (the side
facing the front of the server).
10. Plug the fan sink into the fan sink connector on the system board (J46). Make
sure the cable is not in a position to interfere with the fan sink operation.
11. If you have other options to install or remove, do so now; otherwise, go to
“Installing the bezel and front door” on page 74.
Installing or removing a power supply
Install
ing or
removing
a power
supply
Your server comes with one 385-watt power supply or two 250-watt power supplies.
The 385-watt power-supply configuration can be upgraded with an optional backplane
that will enable you to install up to three power supplies, which enables redundancy
and will make the power supplies hot-swappable. Each power supply has two status
Fan sink
(Remove thermal tape
liner on installation)
Ensure correct alignment
of fan sink, mounting clip,
and mounting socket
Microprocessor
release lever
Spring retention clip
Fan sink guide
Summary of Contents for eServer 232 xSeries
