IBM BladeCenter QS20, Installation And User Manual

Page: 47 / 92

1 0. O ptional: repeat the above steps for the second InfiniBand option.
11 . Prepare the new front be z el by attaching the control panel and serial cable
connectors onto the blade ’ s board.
1 2. Partially insert the side fins of the be z el into the metal guides while ensuring
that the top of the be z el rests on the foam gasket on the InfiniBand card as
shown in Figure 15 on page 3 4.
N ote: Make sure the serial cable, routed along the inside and across the
bottom of the be z el, is housed underneath the blade ’ s board
13 . After you have checked the routing, fully latch the be z el to the blade.
Figure 14. Mounting point and position description
Chapter 5 . Installing and removing replaceable units
33