IBM Aptiva 2156, Hardware Maintenance Service

Page: 88 / 155

2-30
CD-ROM Drive
001 - START
Insert the diagnostics diskette into the diskette drive and make sure that there
is no CD in the CD-ROM drive.
Select Interactive Tests menu, then select and execute CD-ROM Test.
002 - DO YOU SEE A MESSAGE “NO CD-ROM DRIVE OR MSCDEX
DEVICE DRIVER INSTALLED.” ? (YES, READ AHEAD. NO, GO TO
003.)
Exit the diagnostics program and power off the system.
Check and make sure that the CD-ROM drive power cable and audio and
data cables are not damaged and are connected properly.
Check and make sure that the CD-ROM drive driver is loaded correctly.
Load default settings.
003 - DO THE TESTS OF OPEN/CLOSE TRAY BY DIAGNOSTICS
PROGRAM AND BY DEPRESSING CD-ROM DRIVE BUTTON
WORK? (YES, READ AHEAD. NO, GO TO STEP 006.)
Load a known good data CD into the CD-ROM drive and try to read its
content by typing DIR at DOS prompt.
004 - CAN A CD BE READ FROM THE CD-ROM DRIVE? (YES, THEN
THE CD-ROM DRIVE FUNCTIONS NORMALLY. NO, READ
AHEAD.)
Try reading the CD with a known good CD-ROM drive.
005 - IS THE CD STILL NOT READABLE? (YES, READ AHEAD. NO, GO
TO STEP 006.)
Replace system board.
End.
006 -
Replace CD-ROM drive.
End.