IBM 9114-275 - IntelliStation POWER 275, Installation Manual, Page: 42 / 102

Placing the Model 275 into the Service and Operating Position
The Model 275 can be placed on its side or left in an upright position with the side removed in order to
work on the inside of the system unit. When finished working on the system, return it to the position in
which it was placed for customer operations.
Bezel Door
The following procedure covers removal and replacement of the bezel door.
Bezel Door Removal
Refer to the following illustration while you perform the steps in this procedure.
To remove the bezel door, do the following:
1. Open the bezel door by grasping the door handle. Swing the bezel door away from the system.
2. Lift the bezel door release tab located at the bottom of the door in order to clear the post.
3. Gently swivel the bottom of the door forward, out past the bottom of the system.
4. Pull the door down to remove the top retaining post from the bezel.
1 Model 275 4 Bezel Door
2 System Handle Assembly Post Retaining Hole 5 Bezel Door Handle
3 Bezel Door Top Retaining Post 6 Bezel Door Release Tab
7 Bezel Door Lower Retaining Post
Bezel Door Replacement
To replace the bezel door, do the following:
1. Place the top retaining post into the system handle assembly post retaining hole. See the preceding
illustration.
2. Lift the door release tab and rotate the door onto the lower retaining post.
3. Rotate the bezel door toward the bottom of the system.
4. Close the bezel door.
26
IntelliStation POWER 9114 Model 275 Installation Guide