IBM 9114-275 - IntelliStation POWER 275, Installation Manual, Page: 21 / 102

Step 7. Adjust the Stability Feet
To retract the stability feet, push the tabs down and slide the plates inward. To extend the feet, slide the
plates outward until the retraction tabs are fully visible and snap securely into place.
1 Stability Feet Retraction Tabs (bottom view)
CAUTION:
The system is equipped with stability feet to help ensure that the system unit cannot easily be
tipped over. The stability feet might be either standard non-adjustable feet or an adjustable base
stability foot. Ensure that the stability feet are installed and adjusted to their fully extended
position.
C34
Step 8. Check Your Display or Console Type
Notes:
1. If you are using an ASCII terminal with a keyboard as the console for this system, and do not have a
graphics display to connect, refer to “Step 12. Connect the Serial Devices, Parallel Devices, and ASCII
Terminal” on page 9.
2. If you are using a graphics display with a keyboard and mouse, continue with “Step 9. Attach the
Display Cable Toroid” on page 6.
If you ordered a graphics display with your system unit, the graphics adapter has been set to use the
highest display resolution and refresh rate available for that display. If you want to:
v Attach another display to your system unit
OR
v Change the default display resolution or refresh rate
after completing the installation steps, refer to the Customer Installable Options Library CD-ROM for the
documentation for your graphics adapter.
As shown in “Step 9. Attach the Display Cable Toroid” on page 6, connect the graphics display cable to the
back of the display and to the graphics adapter connector. Consult the
″
About Your Machine
″
document for
the locations of installed adapters.
For more information about your display, refer to the documentation included with the display.
Chapter 1. Setting Up the System
5