![background image](http://html1.mh-extra.com/html/ibm/8960-f96/8960-f96_installation-service-and-user-manual_609111052.webp)
1. Screws, 8-32 x 5/16-in., panhead Phillips
Mid-mounting
Observe the following notes when using this procedure:
v
The device must be turned off and disconnected from the fabric during this procedure.
v
The illustrations in this document show a 1U device, but the instructions are the same for a 2U device.
v
The illustrations in the rack installation procedures are for reference only and may not show the actual
device.
Complete the following tasks to install the device in a rack:
1.
“Attaching the front brackets to the device”
2.
“Attaching the front brackets to the rack” on page 33
3.
“Attaching the rear brackets to the rack” on page 34
4.
“Attaching the rear brackets to the device” on page 35
Attaching the front brackets to the device
About this task
Complete the following steps to attach the front brackets to the device.
Procedure
1.
Position the right front bracket with the flat side against the right side of the device, as shown in
Figure 20 on page 33.
2.
Insert four 8-32 x 5/16-in. flathead screws through the vertically aligned holes in the bracket and then
into the holes on the side of the device. Use the upper and lower screw holes, leaving the center holes
empty.
3.
Repeat step 1 and step 2 to attach the left front bracket to the left side of the device.
4.
Tighten all the 8-32 x 5/16-in. screws to a torque of 15 in-lb (17 cm-kg).
Figure 19. Attaching the rear brackets to the device
32
SAN128B-6 Installation, Service, and User Guide
Summary of Contents for 8960-F96
