IBM 8685 - eServer xSeries 255, Installation Manual

Page: 23 / 84

Attention: When you route the SCSI cable, observe the following precaution:
Do not block the ventilated space in front of the fan assembly.
12. If your server is a tower model, reinstall the shuttle assembly in the server.
13. Slide the shuttle assembly back into place and secure it by locking the
metal-hinge latch.
14. Route the SCSI cable from the standard SCSI backplane through the opening
in the adapter-support bracket to the internal channel connector on the RAID
or SCSI adapter.
88
NM
I
PC
IA
PS
1
PS
3
SP
PC
IB
PS
2
PS
4
LO
G
PC
IC
CP
U
FA
N
DA
SD
VR
M
OV
ER SP EC
TEM
P
NO
N RE
D.
J1
J2
J3
J4
J7
J8
J9
J10
J11
J12
J5
J6
RE
MIN
D
SCSI cable
SCSI cable
connector
SCSI cable
connector
Adapter
SCSI backplane
15. Reconnect the internal IDE signal cable to the IDE system-board connector.
Reconnect the diskette-drive signal cable and front-fan signal cable to the
corresponding system-board connectors. See the
Option Installation Guide on
the xSeries Documentation CD for cable locations.
16. Close the microprocessor airflow guide located between the front fans and the
microprocessors. Insert the tabs into the corresponding slots.
17. Reinstall the air baffle and lock the blue fasteners.
18. If you have other options to install or remove, do so now; otherwise, reinstall
the top cover.
19. If your server is a tower model, continue with the next step.
If your server is a rack model and you have already installed the server in a
rack enclosure, you must reconnect the cable-management arm bracket to the
server. See the
Rack Installation Instructions on the xSeries Documentation
CD for details.
20. Reconnect all cables and power cords.
Chapter 2. Installing options
11