IBM 8654 - Eserver xSeries 330, Hardware Maintenance Manual

Page: 34 / 158

26
Hardware Maintenance Manual: xSeries 330
d. Ensure that the battery clip is touching the base of the battery socket by
pressing gently on the clip.
6. Insert the new battery:
a. Tilt the battery so that you can insert it into the socket, under the battery clip.
b. As you slide it under the battery clip, press the battery down into the socket.
7. Reinstall the server cover and connect the cables.
8. Turn on the server.
9. Start the Configuration/Setup Utility program and set configuration parameters.
• Set the system date and time.
• Set the power-on password.
• Reconfigure the server.
Temperature checkout
Proper cooling of the system is important for proper operation and system reliability.
For a typical Netfinity server, you should make sure:
• Each of the drive bays has either a drive or a filler panel installed
• The top cover is in place during normal operation
• There is at least 50 mm (2 inches) of ventilated space at the sides of the server and
100 mm (4 inches) at the rear of the server
• The top cover is removed for no longer than 30 minutes while the server is
operating
• A removed hot-swap drive is replaced within two minutes of removal
• Cables for optional adapters are routed according to the instructions provided
with the adapters (ensure that cables are not restricting air flow)
• The fans are operating correctly and the air flow is good
• A failed fan is replaced within 48 hours
In addition, ensure that the environmental specifications for the system are met. See
“Features and specifications” on page 4.