IBM 8639 - PC Server 325, Hardware Maintenance Manual

Page: 49 / 145

PCNTNW-NW-126 The group bit in the node address
override was cleared.
Explanation: The IEEE address has a group bit
indicating that an address belongs to a group of stations.
This bit is used only as a destination address; it cannot be
used as a source address. You tried to enter a source
address with this bit set. The driver cleared the group bit
of the source address.
Action: None.
PCNTNW-NW-127 The local bit in the node address
override was set.
Explanation: The local bit in the IEEE address format
indicates that the addresses are being managed locally. If
you use the node address override capabilities of this
driver to enter a new address, the local bit should be set.
You entered an address without the local bit set. The
driver has set the local bit.
Action: None.
PCNTNW-NW-164 The device was not found.
Explanation: The driver cannot find an Ethernet
controller in the server.
Action: Perform the following steps:
1. Verify that the Ethernet enable jumper is set to the
default (enable) position.
2. Go to “General Checkout/Diagnostics QAPlus/PRO”
on page 1 to run the diagnostic utility.
PCNTNW-NW-164 Device not found at IOADDRESS.
Explanation: The Ethernet controller cannot be found at
the IO address specified in the NET.CFG file.
Action: Verify that the IO Address in the NET.CFG file
matches with the board. Otherwise, remove the PORT
keyword from the NET.CFG file.
PCNTNW-NW-167 PCI scan specified, device not
found.
Explanation: The driver cannot locate the Ethernet
controller on the PCI bus.
Action: Perform the following steps:
1. Verify that the Ethernet jumper on the system board
is set to the default, enable position.
2. Edit the NET.CFG file to change the BUSTYPE
keyword to PCI1.
3. If the problem persists, go to “General
Checkout/Diagnostics QAPlus/PRO” on page 1 to run
the diagnostic utility.
44
PC Server HMM