IBM 8639 - PC Server 325, Hardware Maintenance Manual

Page: 46 / 145

PCNTNW-NW-071 The matching virtual adapter could
not be found.
Explanation: You tried to load another instance of the
driver with a different I/O address. This new board could
not be found.
Action: If you installed an IBM Ethernet adapter, make
sure the adapter is seated properly. Also, check the I/O
settings of the board with the settings supplied to the drive.
PCNTNW-NW-072 A resource tag is unavailable.
Explanation: The driver tried to allocate some resources
that were not available.
Action: Add or free some memory in the server. Then,
restart the server.
PCNTNW-NW-073 Unable to allocate memory.
Explanation: The driver failed to allocate the memory
needed for normal operation.
Action: Add more memory, or free some memory
resources in the server. Then, restart the server.
PCNTNW-NW-074 The hardware interrupt cannot be
set.
Explanation: An attempt was made to initialize a given
hardware interrupt. The attempt was not successful.
Action: Perform the following steps:
1. Verify that the Ethernet jumper on the system board
is set to the default, enabled position.
2. Make sure that the interrupt request numbers are set
correctly, and that no other devices are using the
interrupt. See “PCI Bus Control” on page 34 for
more information.
PCNTNW-NW-075 The MLID cannot be registered with
the LSL.
Explanation: An error occurred while the driver was
trying to register with Link Support Layer.
Action: Check the version of Netware Operating System.
Make sure that this driver is correct for the version of
Netware that you are using. Restart the server.
PC Server 325 - Type 8639
41