IBM 8275-416, User Manual

Page: 90 / 156

Table 11. Messages - while downloading files (continued)
Message Explanation
TFTP receive complete... updating configuration
For Configuration only: The switch has received the file
and will verify its integrity. The file will be stored in
flash if it passes the integrity checks. The switch will
reset itself after storing the file in order for the newly
loaded configuration to take effect.
File transfer operation completed successfully.
The file has successfully been stored in flash. The
switch must be reset now for the new code to become
operational.
File failed CRC check!
The switch received the file, but detected a CRC error.
Because the file is corrupted, it will not be stored in
flash. Try obtaining another copy of the file.
This file is not intended for this product!
The switch received the file, but detected that the file
was not meant for the switch. The file will not be
stored in flash. If this is for a code update, obtain the
correct software image from the IBM Web site. If this is
for configuration, make sure that the configuration file
originated from a 8275-416 switch.
Failure while storing in flash!
The switch successfully received the file, and began
storing the image in flash; however, an error occurred
during the process. For code only, the flash is most
likely corrupt now and new code will have to be
downloaded via the bootcode utility function. For
configuration, retry the download. If the file transfer still
fails, contact your IBM service representative.
File transfer failed!
A general error occurred. The most likely cause for this
message is when the switch cannot complete the
TFTP operation. This may happen if you have not
entered the correct IP address for the TFTP server, or
if an IP address has not been set up on the switch.
Check to see if your IP addresses are configured
correctly. Also, make sure that you can ping the TFTP
server from the Ping Menu. This error could also occur
if you entered an incorrect path or file name. Check to
make sure these fields match the file location on the
TFTP server.
Uploading trap log, error log, configuration or system trace from
the switch
Table 12. Messages - while uploading files
Message Explanation
TFTP in process...
The switch has initiated the file transfer with the TFTP
server.
Can't start...previous transfer is not
complete yet!
Another TFTP operation is still taking place. Only one
TFTP operation can occur at a given time. This
includes both download and upload operations. Wait
until the previous operation completes.
Error while preparing file for transfer.
Before uploading a file, the switch must prepare that
file for transfer. This message means that there was a
problem either in reading the information required for
making the file, or there was a problem creating the
file. Contact your IBM service representative.
74
8275-416 User’s Guide