IBM 7944, Installation And User Manual

Page: 55 / 150

Figure 21. DVD drive cable connection
The following illustration shows the internal routing and connector for the operator information panel cable.
The following notes describe additional information you must consider when you install or remove the
operator information panel cable:
• You may remove the optional optical drive cable to obtain more room before you install or remove the
operator information panel cable.
• To remove the operator information panel cable, slightly press the cable toward the chassis; then, pull to
remove the cable from the connector on the system board. Pulling the cable out of the connector by
excessive force might cause damage to the cable or connector.
• To connect the operator information panel cable on the system board, press evenly on the cable. Pressing
on one side of the cable might cause damage to the cable or connector.
Attention:
Failing to install or remove the cable with care may damage the connectors on the system
board. Any damage to the connectors may require replacing the system board.
Chapter 2
.
Installing optional devices
45