IBM 7944, Installation And User Manual

Page: 106 / 150

a. Press down and out on the release lever on microprocessor socket 2 and lift up the
microprocessor release lever until it stops in the fully open position.
b. Lift the hinged microprocessor bracket frame into an open position and remove the
microprocessor dust cover, tape, or label from the surface of the microprocessor socket, if one
is present. Store the dust cover in a safe place.
Attention:
When you handle static-sensitive devices, take precautions to avoid damage from
static electricity. For details about handling these devices, see “Handling static-sensitive
devices” on page 43 .
Figure 78. Dust cover removal
c. Locate the microprocessor installation tool that comes with the new microprocessor.
Note:
The microprocessor installation tool assembly comes with the microprocessor and
microprocessor cover attached to the tool. The microprocessor comes protected between the
tool and the microprocessor cover.
Alignment
pins
Microprocessor
Alignment
pin slots
Installation tool
Figure 79. Microprocessor alignment
d. Remove the microprocessor installation tool assembly from the package.
Note:
Do not rotate the handle on the tool until you are ready to install the microprocessor into
the microprocessor socket.
96
System x3550 M3Installation and User's Guide