6.
Position the drive so that it faces you.
7.
Take up slack in the tape by using the following instructions to move the
drive’s trolleys and the supply reel motor.
Attention:
To avoid damaging the tape, do not touch it.
v
To move the drive’s trolleys:
a.
On the left side panel of the drive (toward the rear) locate the hole
marked
UNLOAD
(
1
in Figure 16).
b.
Insert a 2.5-mm L-Hex (allen) wrench approximately 43 mm (2 in.) into
the
UNLOAD
hole. Position it so that it seats securely into the inner socket.
c.
Turn the wrench in the direction marked on the drive (clockwise).
d.
Rotate the wrench until the trolleys
2
stop moving. This may take
more than 120 turns of the wrench.
Figure 16. Moving the Trolleys
32
7208 Model 345 Service Guide
Summary of Contents for 7208 345
