![background image](http://html1.mh-extra.com/html/ibm/7208-345/7208-345_service-manual_608743041.webp)
Removing and Replacing the Drive
To remove the drive from the 7208 Tape Drive:
1.
Perform the cover removal procedure. Refer to “Removing and Replacing the
Cover” on page 26.
2.
Tilt the 7208 Tape Drive on its side. Support the drive (
1
in Figure 12) while
removing the four screws
2
that secure the drive to the chassis.
3.
Support the drive while returning the 7208 Tape Drive to its original position.
4.
Disconnect the power supply connector (J1)
3
from the drive.
5.
Disconnect the internal SCSI bus cable
4
from the drive.
Note:
To remove the cable, grasp the connector and pull it towards you. Do
not pull on the cable.
6.
Disconnect the internal SCSI address cable
5
from the drive.
7.
Slide the drive forward and out of the chassis.
Figure 12. Removing and Replacing the Drive
Chapter 4. Removal and Replacement Procedures
27
Summary of Contents for 7208 345
