IBM 71412RU, User Manual

Page: 48 / 102

AC power
LED (green)
DC power
LED (green)
Error LED
(amber)
Release latch
Release latch
Power supply
filler
Hot-swap
power supply
To install an additional hot-swap power supply, complete the following steps:
1. Read the safety information that begins on page v and “Handling static-sensitive
devices” on page 30.
2. Press the blue release latch on the filler panel and pull the handle to the open
position, then remove the filler panel from power-supply bay 2.
3. Press the orange release latch on the power-supply handle and pull the handle
to the open position.
4. Slide the power supply into the bay and fully close the locking handle.
5. Connect one end of the power cord for the new power supply into the ac
connector on the back of the power supply, and connect the other end of the
power cord into a properly grounded electrical outlet.
6. Make sure that the ac power LED on the power supply is lit, indicating that the
power supply is operating correctly. If the server is turned on, make sure that
the dc power LED on the top of the power supply is lit also.
Installing a hot-swap hard disk drive
The following notes describe the types of hard disk drives that the server supports
and other information that you must consider when you install a hard disk drive:
v The server supports up to four 1-inch (26 mm) slim-high, 2.5-inch, hot-swap hard
disk drives in the standard hot-swap bays.
v
For a list of supported optional devices for the server, see http://www.ibm.com/
servers/eserver/serverproven/compat/us/.
v Inspect the drive tray for signs of damage.
v
Make sure that the drive is correctly installed in the tray.
36
IBM System x3850 M2 and System x3950 M2 Types 7141 and 7233: User’s Guide