IBM 5104-22C, Installing And Configuring

Page: 33 / 148

Red Hat Enterprise Linux (RHEL) version 7.2
To run the rescan command in the REHL version 7.2 operating system, log in to the system as the
root user, and run the following command:
rescan-scsi-bus.sh -a
The rescan-scsi-bus tool is available in the sg3_utils package; install the package by using the
following command:
yum install sg3_utils
You can also refer to: Adding a Storage Device or Path (https://access.redhat.com/
documentation/en-US/Red_Hat_Enterprise_Linux/7/html/Storage_Administration_Guide/logical-
unit-add-remove.html).
10. Load or restore data from your backup media.
Installing a rear disk drive in the 9006-22P system
Learn how to install a disk drive in the rear of the IBM Power System LC922 (9006-22P) system.
Before you begin
Rear drives are an optional feature. You can install SATA and SAS rear drives with the system powered on
and running.
About this task
Procedure
1. Attach the electrostatic discharge (ESD) wrist strap.
The ESD wrist strap must be connected to an unpainted metal surface until the service procedure is
completed, and if applicable, until the service access cover is replaced.
Attention:
• Attach an electrostatic discharge (ESD) wrist strap to the front ESD jack, to the rear ESD jack,
or to an unpainted metal surface of your hardware to prevent the electrostatic discharge from
damaging your hardware.
• When you use an ESD wrist strap, follow all electrical safety procedures. An ESD wrist strap is
used for static control. It does not increase or decrease your risk of receiving electric shock
when using or working on electrical equipment.
• If you do not have an ESD wrist strap, just prior to removing the product from ESD packaging
and installing or replacing hardware, touch an unpainted metal surface of the system for a
minimum of 5 seconds. If at any point in this service process you move away from the system,
it is important to again discharge yourself by touching an unpainted metal surface for at least
5 seconds before you continue with the service process.
2. Unlock the drive bay handle (B) by pushing in the handle release (A) as shown in Figure 16 on page
20. The handle (B) snaps out towards you. If the handle does not snap out all the way, the drive does
not slide out of the system.
Installing and configuring your system and system features 19