IBM 4230 - Model 4i3 B/W Dot-matrix Printer, User Manual, Page: 225 / 320

Guideline for Training
To introduce a new operator to the printer, use the following steps as
a guideline. Change the steps, as needed, to suit your working
environment and the operator’s level of responsibility.
1. Show the operator this guide and discuss the contents of
Chapter 1, “Setting Up the 4230 Printer.”
2. Show the operator
Ÿ IBM 4230 Printer Models 101, 1S2, and 4S3 Quick
Reference Guide or IBM 4230 Printer Models 201, 2S2, and
5S3 Quick Reference Guide (depending on the model
installed)
Ÿ IBM 4230 Printer Models 101, 1S2, 201, 2S2, 4S3, and 5S3
Operator Panel Instructions
and discuss the contents of each.
3. The power cord should be unplugged before connecting or
disconnecting the signal cable. See Chapter 1, “Setting Up the
4230 Printer” for the proper sequence.
4. Show the operator how to install the forms device with emphasis
on identifying the type of forms device (F1, F2, F3, or F4). Show
the operator where the procedures are in Chapter 1, “Setting Up
the 4230 Printer” or in
IBM 4230 Printer Auto Sheet Feeder
General Information (depending on the forms device installed).
5. Show the operator how to set the forms device number. Show
the operator where the procedures are in Chapter 1, “Setting Up
the 4230 Printer” or in
IBM 4230 Printer Auto Sheet Feeder
General Information (depending on the forms device installed).
Appendix A. Training Guideline
A-3