IBM 4230 - Model 4i3 B/W Dot-matrix Printer, User Manual, Page: 209 / 320

Printer Configuration
You can print the current values for each parameter. Each
parameter is shown with its corresponding value printed to the right.
The category and parameter names are printed in the current Display
Language used on the operator panel. The current custom set is
noted at the top right column of the configuration printout. If you
need to verify each custom set, the Operator Print Tests must be run
for each custom set. The custom set must be changed in the
|
configuration menu before running each configuration printout. See
|
Figure 5-1 on page 5-10, Figure 5-2 on page 5-11, Figure 5-3 on
|
page 5-12, Figure 5-4 on page 5-13, Figure 5-5 on page 5-14, and
|
Figure 5-6 on page 5-15 for sample printouts.
Printer configurations can be checked by entering the configuration
menus.
To print the printer configuration:
1. Enter the Operator Print Tests (see “General Test Instructions”
on page 5-1).
The printer displays
2. Press Scroll
↑
or Scroll
↓
until the printer displays
3. Press Enter or Start to begin the test.
The Ready indicator goes on and printing begins. The printout
shows the current configuration. The configuration printout is
complete when the Ready indicator goes off.
4. The printer returns to the Operator Print Tests menu
automatically when the configuration printout is complete.
OPERATOR PRINT TESTS
Printer Demonstration
OPERATOR PRINT TESTS
Printer Configuration
Chapter 5. Tests
5-9